MY Tin Man 1st Service report

Engineer’s report,

Worked with Mycale pulling Cat 5 and Creas net L2 cable from the Main Salon Aft Door location of transformer, Down into Eng. room and back up to the overhead in the main salon fwd. and up to fly bridge. L1 Main salon overhead up to flybridge. L3 Stb Cabin up to Fly Bridge. L4 Master state room up to fly bridge. 9/22/ 2013 Pulled Camera cables to the flybridge from the Aft Steering location, Fwd Port Eng.room,Fwd. Stb Eng. room. Had to remove panels in the generator room to gain access to port engine room. Than re install them. 9/23/2013 Pulled back Aft camera cable and re pulled it to Fly Bridge aft overhead. Dressed Cable runs for Crestron lighting controls from Master Stateroom, Stb Cabin, Salon overhead by the stairs and Aft salon Door up into flybridge and labelled and coiled up cables under helm., Dressed cable runs under Galley sink down into the generator room. Cut hole into Master State room closet to run new lighting control cables. Re installed Panel at Fwd Eng. Roomcable chase.